No Displacement / Stress Result after Simulation - Optistruct

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hi Everyone, 

 

I am working with Optistruct for my Linear/Static Analysis, I am doing Topology Optimization in my model but before I wanted to check whether my model is working regarding with displacement or stress result for my BCs. but after analysis result it shows nothing every displacement result is zero and no change. Can anyone take a look into my model whats wrong or what change I have to make. I used Hex mesh, with 4 Loadcases and one constraint. I have attached my model for the expect reference. It would be much apprieciated if i get any positive response. Thank you in advance.

 

Regards,

Muthu.

 

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited October 2017

    Hi Muthu,

     

    You have applied loads and Bcs on temp nodes. Delete temp nodes and create loads and BCs again.

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited October 2017

    @Prakash Pagadala  Thanks alot Bro, Worked !!! I deleted my temp nodes and created my loads and BCs now working. Thanks :)) Have a wonderful day. If I have any other problem with my simulation I will ping. 

     

    Kind Regards,

    Muthu.

Categories