Hello,
attached you'll find my model. I would like to attach the 4 lines to the circle on the one side of my model. Any ideas how to do that?
My previous attemps:
- I tried geom>nodes> on geometry already, put nodes on the end Point of the 4 lines and on the circle and tried to connect both.
However, Hypermesh won't place the nodes right on the geometry itself but a little offset. Therefore whenever I try to create a surf and subsequently a solid of the 4 lines and the circle,
I would end up getting an error.
- geom>line edit> Combine or extend line. I get Errors when I try to connect the lines to the circle, as Hypermesh doesn't know to connect both. It probably needs nodes to connect
properly.
Any help is very much appreciated.
Kind regards,
Niclas
Unable to find an attachment - read this blog
