Polynurbs crashes
Extruding a polynurbs face causes crash all the time. Some other operations with polynurbs do that as well.
Is this a known problem on 2022.2 ? i think this version is crashing in general more that some previous versions.
When can we expect a new version?
Find more posts tagged with
Hi Antonio,
Is Apple silicon support on your roadmap?
Best,
Ari
Altair EmployeeHi Ari,
As reported in the Inspire Studio 2022 What's New document:
• Mac M1 hardware will not be supported.
https://2022.help.altair.com/2022/studio/whatsnew/InspireStudio_2022_ReleaseNotes_English.pdf
M2 will not be supported too.
Regards,
Antonio
Thanks Antonio for your reply.
Too bad, I think I am not the only one who started with you because you were doing a serious modeling software for designers using mac. And now Apples recent machines being very powerful.
Best,
Ari
Hi Ari,
The new version 2022.2.1 is already done internally.
If no other issues are found it should be available in a week or so.
Ciao!
Antonio