When nodes have been put on surface before mesh, the nodes do not cross the mesh

Pari_20321
Pari_20321 Altair Community Member
edited March 2022 in Community Q&A

hi,

 

I'm new to HyperWorks and I noticed that when I put some nodes on a surface, the mesh does not cross them (see photo below). Eventually I see the results are not right because of this.

Can someone please help?


thank yo in advance.

 

image
image

Tagged:

Answers

  • Matthias Goelke_22079
    Matthias Goelke_22079 New Altair Community Member
    edited March 2022

    Hi,

    Apparently, you have created so-called temporary nodes (in yellow). These nodes are not recognized during the meshing (as you are meshing the surface/geometry). Hence, you need to create geometry points instead (you will see, that geometry points will also be highlighted when you select the geometry).

    Regards

    Matthias

Categories