DSPInterface won't run unless connected to Plot Block

User: "Altair Forum User"
Altair Employee
Updated by Altair Forum User

Submitted by Joe on Wed, 11/04/2009 - 08:03 

I have noticed that if I don't connect the output of the DSPInterface block to a 'plot' it does not execute when 'run' is given. Please advise.

Find more posts tagged with

Sort by:
1 - 1 of 11
    User: "Altair Forum User"
    Altair Employee
    OP
    Updated by Altair Forum User

    Submitted by Anders89 on Wed, 11/04/2009 - 08:08.

    VisSim only executes a block if it is observed by being connected to a signal consumer. This can be a plot, display, meter, histogram, export, PWM, etc. If you want to run the DSPInterface block without connecting it to a consumer block, make sure it has no outputs by unchecking theShow CPU Utilization option.