Setting automesh parameters in HM 2017

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

The tcl command 

 *set_meshedgeparams 0 1 0

does not seem to work in HM 2017 however it works just fine in 14. Is there any reason this could be happening and any way to correct it ?

I am trying to use 

 *set_meshedgeparams

as a precursor command to 

 *hmmeshspline

 

Are any of the above commands deprecated in HM 2017 ?

 

Thanks. Any help is appreciated.

Tagged:

Answers

  • tinh
    tinh Altair Community Member
    edited November 2017

    i think it has more args than you said

    you can find deprecated commands in hm release notes

Categories