Invalid AcuRun path in Altair Hyperworks CFD Software

Hi everyone, I have a question, I have successfully meshed my model, when it comes to "Launch Acusolve", I press the "run" and "export" but it shows the error of Invalid "AcuRun path", I would like to know what is the root of the problems (maybe installation path, the file or anything that could impact the cfd simulation? Attached is the picture of explained problem faced in Altair Hyperworks CFD - Acusolve. I would appreciate your thoughts on it, and thank you.

Find more posts tagged with

AcuSolve

English

HyperMesh

Accepted answers

All comments

Junta_20361

hi,

1. Make sure that you installed AcuSolve on your PC. AcuSolve and HW CFD are separated. They need 2 different installers. >> check the Start Menu and look for AcuSolve or AcuSolve cmd prompt.

2. In case AcuSolve was installed, in the run dialog of HW CFD, you need to provide the address for AcuRun path.
Like below example:
Remember to modify the number (202x.xxx) to match your AcuSolve version.

Altair Newbie

hi,

1. Make sure that you installed AcuSolve on your PC. AcuSolve and HW CFD are separated. They need 2 different installers. >> check the Start Menu and look for AcuSolve or AcuSolve cmd prompt.

2. In case AcuSolve was installed, in the run dialog of HW CFD, you need to provide the address for AcuRun path.
Like below example:
Remember to modify the number (202x.xxx) to match your AcuSolve version.

Hi @Junta ,

Noted, thank you.