The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Submitted by ferdosinezhad on Fri, 08/26/2011 - 20:21
For some reason the X-axis on the diagram doesn't go beyond 10sec. how do i resolve this?
Submitted by a_a on Fri, 08/26/2011 - 20:43.
Most likely you have fixed plot bounds. In your plot block, bring up the properties dialog box, the first checkbox is 'Fixed Bounds'. It must be unchecked.
Another possible cause can be the simulation configured to run for 10 seconds. In the menu, go to System > System Properties and chnge the End value.
Submitted by ferdosinezhad on Sun, 08/28/2011 - 11:56.
You're the best! it was the latter case! Changed the end value and now it's working just fine. /emoticons/default_smile.png' srcset='/emoticons/smile@2x.png 2x' title=':)' width='20'>
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…