HyperMesh Crash File

Jan Grasmannsdorf_20379
Jan Grasmannsdorf_20379 New Altair Community Member
edited October 2020 in Community Q&A

Hello,

 

when HyperMesh closed down suddenly, a crash0.hm file has been saved on my computer. Unfortunately some of the entities (like Plies etc.) are missing after the HyperMesh Crash. How can I prevent this?

 

 

Tagged:

Answers

  • Jan Grasmannsdorf_20379
    Jan Grasmannsdorf_20379 New Altair Community Member
    edited October 2016

    There is no direct way to influence the automatically created crash.hm file. It should not happen that the automatic save goes wrong, but unfortunately sometimes it does.

     

    A way to restore your data is to import your last solver deck (like *.fem file for OptiStruct solver) through file - import - solver deck into HyperMesh. This solver deck is created everytime you run a simulation and therefore should contain all your relevant FE data. The solver deck does not contain the CAD geometry however.

     

    Best Regards

     Jan

Categories