Try to make mapable but some part is not mapable. how to done mapable other part some is tell me.

Ava Mary
Ava Mary Altair Community Member
edited March 2022 in Community Q&A

imageturbine.STEP is as file i try to make mapable but some part is only done and I face problem in some part. How can do this.

 

Tagged:

Answers

  • Ben Buchanan
    Ben Buchanan
    Altair Employee
    edited March 2022

    Yes this is a tricky one.  The connections to the fins and the shaft is what makes these unmappable.  For the ones on the shaft it is a pretty easy fix. If you split the solids as if the smaller diameter shaft is continuous that should make those mappable. 

    The fins are a little trickier.  I really good approach isn't coming to mind right now. Maybe split up the cylinder to just one section with one fin, mesh that manually then copy it, rotate it and equivalence nodes.  That is not a very elegant solution.  Maybe someone else will have a good idea for that area.

  • Ava Mary
    Ava Mary Altair Community Member
    edited March 2022

    Thankyou,but It's not done

  • Ben Buchanan
    Ben Buchanan
    Altair Employee
    edited March 2022
    Ava Mary said:

    Thankyou,but It's not done

    Were you able to get the two cylinders on the right to show up mappable?

  • Ben Buchanan
    Ben Buchanan
    Altair Employee
    edited March 2022
    Ben Buchanan said:

    Were you able to get the two cylinders on the right to show up mappable?

    I split up the model a little more.

Categories