Temp card

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

hi,

i am using hypermesh 14.0 to simulate a tensile test in 3D, i want to do that in quasi-static non- linear mode, in the tutorials i found the loadsteps option exists in setup panel, but that is version 12.0 i think, where can i find the same option in version 14.0 of hypermesh, thx in advance

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited June 2017

    Hi,

    In Analysis page, you can find the option to set up loadsteps.

     

    <?xml version="1.0" encoding="UTF-8"?>LS.PNG

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited June 2017

    hey,

    thx for your reply, however loadsteps is even missing in the nalysis panel.

    <?xml version="1.0" encoding="UTF-8"?>Capture.PNG

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited June 2017

    i use Radioss as my solver

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited June 2017

    Hi,

    The Loadsteps panel is available only for the Nastran or OptiStruct user profile and for RADIOSS we don't create loadsteps.

Categories