Errors in CMA solver

Altair Forum User

Dear experts,

I met thses problems that I was unable to slove.

When I created a UWB antenna model without CMA, it shows NOTICE about 'checksum mismatch'.Then I added CMA to the model, it shows ERROR about eignsolver.The model can be downloaded in .zip file.

 And I want to know the solution to these and reasons so that I could continue my study in CMA.  Thank u!

 

<?xml version="1.0" encoding="UTF-8"?>

<?xml version="1.0" encoding="UTF-8"?>

<?xml version="1.0" encoding="UTF-8"?>

<?xml version="1.0" encoding="UTF-8"?>

<?xml version="1.0" encoding="UTF-8"?>

Unable to find an attachment - read this blog

Wilco Strydom

Hi Lydia.

 

I see you are a University User, are you able to update your Feko version?

Your outfile reports

 FEKO.CSV  Version 2018.1-424 from 2018-07-20

I suspect this error is triggered by the dielectric-metallic junctions shown in your first image. If that is the case then updating should resolve your problems as that error has been fixed.

Good news is that this error is only triggered in parallel runs, so if you cannot update the solver you could always just perform the run sequentially.