Mr.

When I run the followimng it shows an error saying:

' *** See next message about line 5077 from file: /Project_1/Try_3
'CQUAD4 1 0 205 206 207 310'

*** ERROR # 1000 *** in the input data:
Incorrect data in field # 3.

would be reall grateful if someone could help me out

thanks

Unable to find an attachment - read this blog

Find more posts tagged with

English

HyperMesh

Accepted answers

All comments

Altair Forum User

Hi,

Please try with the attached model file.

Unable to find an attachment - read this blog

Altair Forum User

Thanks once again George. Could you please tell me what did you change exactly?

Altair Forum User

Hi,

The issue was with the loadstep where you activated the flag for retrieval of eigenvalue which is normally used in modal frequency analysis and the same was removed.

Altair Forum User

Hi,

Okay. Thank you

Altair Forum User

hey george

One more question. For the above model, if I have to apply 100MPa on one of the edges of the model, can I just use the 'force' boundary condition to generate it.

Thanks

Sincerely

Altair Forum User

Hi,

For MPa units you have to apply the pressure load, and you can apply pressure loads only on the element faces.

If you are trying with force load (N) then you have to select force load collector., which you can apply on the nodes. Suppose you are applying a force 100N in an edge with 10 nodes, select the 10 nodes and enter the magnitude as 10 in the force panel(that is 100 divided by the number of nodes 10).

I recommend you to go through a similar tutorial in our Help Menu which is attached along. The model file is also attached for practice.

Unable to find an attachment - read this blog

Altair Forum User

Thanks george once again and sorry for troubling you again and again.

I made a solid element this time around and gave the model a thickness of 5mm. Howeever it agains shows the same error as before.

I have a attached the model

Please help me

Unable to find an attachment - read this blog

Altair Forum User

Please reply! it is bit urgent

Altair Forum User

Hi,

There were shell elements in the model which were deleted and no property was assigned to the model.

Please check with the model attached.

Unable to find an attachment - read this blog

Altair Forum User

thanks a lot once again