Hypermesh Refinement Zone Using Mesh Controls
Altair EmployeeHi,
The Objective is to mesh the volume from existing 2D Mesh by introducing refinement zone. Hence, 2D Mesh should also be refined while volume tetra mesh is imitated through Mesh Controls.
The Observation made after volume meshing is that the refinement specified is not propagating to 2D Surface mesh. Please help me refining surface mesh also when I perform volume mesh.
Regards,
Vignesh V.
Find more posts tagged with
Sort by:
1 - 1 of
11
Hi VigneshKPV
I have attached a document explaining about the mesh controls and refinement zone. Please check whether you have prepared your mesh control tab accordingly.
Thanks
Unable to find an attachment - read this blog