Roll cage triming
Altair EmployeeHi guys,
I have started using Hyper work software for analysis of Roll cage. I have been triming the surfaces of tubes. But when I trim the bent tubes with straight tube,the surfaces are twisting and going irregular. Due to this I'm unable to go further.
Any help or suggestions is really helpful.
And I'm new to this forums, If any details are still needed... Please do mention!
Answers
-
Hi karthik,
Please can you show some images of your issue. If possible please share your model.
Please use below FT link.
https://ftin.india.altair.com:8443/filedrop/~osKE8Q
Thank you
0 -
Please can you share the model file.
Thank you
0 -
Sir I have sent you the file. Any suggestions please!
0 -
Sorry for late reply. When you trim the surface you need to remove unnecessary points and lines, and then trim the surface. I suggest you to go through the below video, where it is explained clearly how to edit geometry of the Roll Cage.
Thank you
0