The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Submitted by Joe on Wed, 07/06/2011 - 21:51 Hello, I need to make a signal that toggles between 0 and 1 every other step. How can I do this? Joe
Submitted by Anders89 on Wed, 07/06/2011 - 21:54.
just put a not block in feedback with a 1/Z. See attached diagram below (you must be logged in to see it).
Unable to find an attachment - read this blog
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…