End user disclaimer sign-off feature at model entry

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Submitted by vinayak on Fri, 01/22/2016 - 01:23 

I want to provide a system model to others with a feature that pops a disclaimer note and unless user accepts it, the model would not open. Would like to know how this can be done in VisSim model? Thanks,

Tagged:

Answers

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited June 2016

    Submitted by pete on Fri, 01/22/2016 - 02:27.

    Vinayak, Enclose the entire diagram int a single compound that contains the disclaimer as it's name. It can say at the end, 'right click on this block to accept these terms and run this model, or chose file/close if you do not accept these terms'. Note you can password protect portions you don't want exposed to the end user. Pete

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited November 2020

    Submitted by anthony on Sat, 01/23/2016 - 17:04.

    Vinayak,

    Another way that you can achieve this is by using the error block as in the attached diagram.

    You will be asked at the start of the first simulation run to accept the disclaimer conditions or the simulation will be stopped. The disclaimer can otherwise be permanently accepted by checking the check box in the compound block dialog constant. Anthony

    Unable to find an attachment - read this blog

Categories