Part analysis error after running topology optimization, what could be the problem? screenshot attached

Ripfumelo
Ripfumelo Altair Community Member
edited October 2023 in Community Q&A

image

Tagged:

Answers

  • Johan Dahlberg_20306
    Johan Dahlberg_20306
    Altair Employee
    edited October 2023

    Hi Ripfumelo
    So best way is to use the Partition tool in inspire to create bosses/hubs around holes etc. This will create seperate parts so that no loads or boundary condition are directly attached to the design space part!
    image

    Hope this help!
    /johan

  • Ripfumelo
    Ripfumelo Altair Community Member
    edited October 2023

    Thanks Johan, that helped me sort out the issue, it's now running fine.

Categories