The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Hi everyone,
Can anyone help me remove these manifold/non-manifold edges in HyperMesh 2025.1?
What is the recommended workflow or tool to remove these manifold edges without affecting the geometry?
Any suggestions would be greatly appreciated.
You could look into the Surface Repair tool. But I would verify you actually dont want them. In themselves, they are not incorrect, they are just where 3 or more surfaces meet, like a T connection. Which is perfectly acceptable and correct.
I will also take this opportunity to make sure you are aware of Altair CoPilot
