nav[aria-label="Primary Navigation"] { padding: 0; & ul { list-style: none; width: 100%; display: flex; flex-direction: row; justify-content: start; align-items: start; gap: 30px; padding: 0; & li { margin: 0; } & ul li { list-style: none; } } }

Siemens Community Catalyst Program

The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.

Nominate Now

In the HyperView post-processing interface, the Contour display shows "No Result" and the Result typ

不废江流

When I used MotionView for the coupling of rigid and flexible components, after the simulation was completed, I used HyperView to view the relevant forces. However, in the post-processing interface of HyperView, there was a situation where the Contour (cloud map) displayed "No Result" and the Result type was empty. I don't know where the problem lies.

Find more posts tagged with

HyperView

MotionView/MotionSolve

Accepted answers

All comments

不废江流

The software versions used are all 2025.

Orestis_YB

Hello @不废江流,

which H3D did you load in HyperView? Have you used the MotionSolve result h3d? Did you accidentally select a flexbody h3d? Could you maybe share the log of your simulation and the h3d maybe?

As I see animation in MotionView enviroment I suspect that you run in default settings.

Can you to run your model in offline mode and maybe xml format?
Fo to Analyze tab → Simulation Settings→ Check Run Offline→ Use XML format

After the simulation finishes click on the results button on the log. HyperView will load automatically with the animation.

Hope this helps!

Best regards,
Orestes

不废江流

posui-dandao20260605_Run.log

Hello, in the result file loaded by HyperView from MotionSolve, there are three crushing shafts in the excavating bucket. We will make the crushing shafts into flexible bodies, and then replace the rigid shafts in the entire model file with Flexbody H3D. Currently, in HyperMesh, it is possible to display the stress and strain of three shafts. However, a new problem has arisen. The H3D file only contains the file for the flexible body shaft, and there are no other components. Could you please tell me where the setting might be incorrect? Thank you very much.

不废江流

Due to the large size of the h3d file, it is currently not possible to upload it.

不废江流

Currently, MotionSolve and EDEM are coupled, both using version 2025. After the simulation is completed, the h3d file only contains the rigid body file and lacks the other components.

Orestis_YB

Hello @不废江流,

are the componenets also missing from the list of components on the left side? Can you try hiding the shafts and and maybe zoom? Where the graphics in MotionView in proper dimmension? Unfortunately, I cannot really tell from the shared log or the picture. I would suggest creating a support case in Support Center where you can upload your model as well.

Hope this helps!

Best regards,
Orestes

不废江流

OK, I'll create a support case in the support center. You can upload the model.