Question about a post regarding MotionView coupling with EDEM and Inspire in the community.

Jin1

This post explains using Inspire to parameterize the geometry, then importing the parameterized model into EDEM, and finally coupling it with HyperStudy. I understand all the steps up to this point.

However, I’m confused about the part where the parameterized geometry is imported into EDEM and then coupled with MotionView. Since the parameterized geometry has already been imported into EDEM, at which step is the bucket model in MotionView updated? I don’t quite get this part.

Original post link:

パワーショベルの掘削シミュレーションにおけるバケット形状のDOE・最適化 - Altair Community

PrasadAvilala

Hi Jin,

I was not sure about this workflow, but the bucket parameterization might work as given below

Assume there is a base bucket design and ran the simulation and understood that there is some design change is required which is obtained using parametrization and exported the bucket and can be replaced the bucket geometry in motion view with modified bucket design and then simulation carried out using modified geometry.

I hope this is a possible scenario.

Thanks,

Prasad A