Problem avec MotionView design vehicule

Question

Je suis en train de changer le graphic de le vehicule mais apres quand je simmula ca ferme tout et je ne sais pas pourquoi

Christopher_Fadanelli · Answer

Hi @PedroNeto ,

With crash reports like this, it will be difficult to diagnose the exact issue without confirming whether it occurs on other machines. Please try the following for me:

* Open a new session, do not replace the body graphics, and run the model.– Does it run?
* Then try altering the vehicle graphics and run the model again.– Does it run in this case?

If the model is confidential and not intended for public sharing but can be shared to Siemens/Altair, you can create a ticket on our Support Site, upload the model, and one of us will assist you directly.

Best,

Christopher Fadanelli

PedroNeto · Answer

Je peut pas envoyer le fichier monsieur desole cest confidenciel… cest possile de faire un point avec vous pour regler cest probleme?

Merci cordialment Pedro

Christopher_Fadanelli · Answer

Hi @PedroNeto ,

I'm sorry that you are experiencing this. Could you please share the archive model and the graphic file that you will be replacing the vehicle body with? I would like to replicate on my end.

Best,

Christopher Fadanelli