Need help for Single Wheel Analysis of front end

ray9209

Hi,

I am new to Altair Motionview and need help in the project I am doing. My goal is to generate kinematic results for the single wheel using the task wizard, the simulations runs good at steering angle=0 (default). Further, I want to do the analyses for different steering angles (Eg. -100, 50, 0, 50, 100 degs) and compare the results.

So, how can I add this additional motion to my model, I have tired adding but the model shows error during initialization. Please guide if their is any other way to reach my goal!

Thanks…

Orestis_YB

Hello @ray9209,

which are the desired output request when you're saying single tire kinematics? What kind of simulation are you running? Do you use a model from the assembly wizard like front or rear end or single tire test rig? Do you use a build in simulation event like KnC or other? In KnC documentation you can see how the event is created and what kind of test are performed. Also in MotionSolve for Vehicle Modeling eLearning you can see how to set up your model for a KnC.

Hope this helps!

Best regards,
Orestes