Here could someone tell me what is the unit of quantities we are using in hypermesh here? Like i made a 3d block here of 0.2 x 0.6 x 0.01 so what is this 0.2 or 0.6 or 0.01 is it metre is it centimetre or what is it?
Similarly if i am defining loads let's say an edge load of magnitude 1.0 as it is set by default so what is that? is it newton or some other quantity. Like in general also where do i go and refer about these units of quantities i am using
Similarly, in my topology optimisation output, i get contours of elemental densities so what is the unit of it, what is that quantity and most importantly where can i read about it
