NOTE 32313: The *.str file is not valid for the current solution (checksum mismatch)

nicolo
nicolo Altair Community Member

Hello,
I am quite new to FEKO. I performed a simulation from start to end for a complex structure. Now I added an additional request on the results and it seems the calculation has to rerun the full solution as I get

NOTE 32313: The *.str file is not valid for the current solution (checksum mismatch)

Is it normal?

Thanks for the support
Nicolo

Tagged:

Answers

  • Zeina
    Zeina
    Altair Employee
    edited January 23

    Hi @nicolo ,

    If only a request has been added, without modifying other model parameters, then normally the solver does not rerun from scratch the same solutions it has already computed. What type of request did you add?

    Best,

    Zeina

  • nicolo
    nicolo Altair Community Member

    Hello,

    I added a near field request only.

    yes, that was what I expected. Is it maybe configuration dependent?

    Thanks

    Nicolo'

  • Zeina
    Zeina
    Altair Employee

    Hi @nicolo ,

    Ok, so you have added a configuration, to which you have added a new request.

    Indeed, in this case, the runs perform again.

  • nicolo
    nicolo Altair Community Member

    Normally the configuration is already there, I just added a new request within it. But I will check further to try and figure out what is happening…