Irregularities in meshing

sbhbajra
sbhbajra Altair Community Member

I am trying to mesh the circular part of a K joint. I have assigned equal densities in opposite sides. But when we go to the inner region, the density is decreased. I was expecting to have elements in concentric circles which is true at the edges but not in the middle.

Other condition is when I have 7 element in one side and 6 element in other side, then there is one triangle element, other are well distributed

Could there any adjustment to the setting

Answers

  • QNGUYENDAI
    QNGUYENDAI Altair Community Member

    Split your surface into 2 or 4 so you have more control over your mesh.

  • sbhbajra
    sbhbajra Altair Community Member

    Thank you very much for your reply, but i am experiencing this issue even for smaller sections like brace interpolation area which is a simple rectangle.