Bearing Stiffness

CdricCd
CdricCd Altair Community Member
edited October 2020 in Community Q&A

Hi !

 

I was wondering if the bushing element was a good way to design bearing stiffness (trans+rot) in MotionView ? If no what is the best way ?

 

Thanks ! :)/emoticons/default_smile.png' srcset='/emoticons/smile@2x.png 2x' title=':)' width='20' />

Tagged:

Answers

  • Praful
    Praful
    Altair Employee
    edited February 2018

    Yes, bushing is quite commonly used to represent bearings. Based on the type of bearing, one has to chose the rotational stiffness appropriately. One could also use the 'Curve' to represent the Force-Deflection specially for out of plane rotation directions as they tend to be non-linear in nature.

  • CdricCd
    CdricCd Altair Community Member
    edited February 2018

    Ok thanks a lot ;)/emoticons/default_wink.png' srcset='/emoticons/wink@2x.png 2x' title=';)' width='20' />

Categories