How to exclude elements links to RBE2 and CBUSH in the analysis ?

arthur blaise_20814
arthur blaise_20814 Altair Community Member
edited February 21 in Community Q&A

Hello,

I would like to exclude elements links to RBE2 and CBUSH in the analysis. In previous versions of hypermesh, I used a set and to choose those elements: 

By config (-> Rigidlinks, and CBUSH) : RBE2 and CBUSH are selected

By adjacent, -> elements links to RBE2 and CBUSH are selected

But in Hyperworks 2021.2, I don't find By adjacent.

Is there an other method to do this ?  

Tagged:

Best Answer

  • Marine_Racollet
    Marine_Racollet
    Altair Employee
    edited February 21 Answer ✓

    Hello,

    If you are using The New HyperMesh you can select RBE2/CBUSH using By config then you can use the shortuct CTRL+J or right click > Select > Adjacent.

    Regards,

    Marine

Answers

  • Marine_Racollet
    Marine_Racollet
    Altair Employee
    edited February 21 Answer ✓

    Hello,

    If you are using The New HyperMesh you can select RBE2/CBUSH using By config then you can use the shortuct CTRL+J or right click > Select > Adjacent.

    Regards,

    Marine

  • arthur blaise_20814
    arthur blaise_20814 Altair Community Member
    edited February 21
    Marine Racollet_22477 said:

    Hello,

    If you are using The New HyperMesh you can select RBE2/CBUSH using By config then you can use the shortuct CTRL+J or right click > Select > Adjacent.

    Regards,

    Marine

    Thank you Marine,

    It's exaclty what I was looking for !

     

Categories