How to select dependent node with radius limit in hypermesh like simlab

Eddy _20769

I aim to create an RBE at the center of a surface, bounded by a limit circle, in HyperMesh's new interface.

I had done it in Simlab before, but I don't know how to do this in hypermesh (new interface).
Here is how to select the node on the surface with a limited radius and centroid with Simlab. 

Here is in hypermesh

Mickael

Hello @Eddy ,

 

we do not have selection by Radius in HyperMesh. However HyperMesh allows to detect automatically holes, especially if you use Attachments in the connector ribbon. In that case the rigid is created automatically as soon as a hole is detected. Would that help?

 

Brest Regards,

Michael