Repeat geometry

User: "Snehal Shinde_22591"
Altair Community Member
Updated by Snehal Shinde_22591

I imported geometry from CAD. but due to incorrect geometry I just kept one pole pair section of motor with correct geometry. Now I want to repeat this section. but want to use section for analysis not a complete motor structure. should I use circular repetition or periodicity ?

Find more posts tagged with

Sort by:
1 - 1 of 11
    User: "asoualmi"
    Altair Employee
    Updated by asoualmi

    Hi,

    In your case you want to study just one part of the motor. This means that you need to use a periodicity. In Flux there is also a function allows to see whole geometry when you use a periodicity/ symmetry (see attached picture).

    Best regards.