Offsets for composites in Radioss

Ben Raeves
Ben Raeves Altair Community Member
edited September 25 in Community Q&A

Hi There,

I'm trying to define a composite from some tooling geometry so I want the composite to lay plies on just one side of the geometry. I have defined Z0 = 0.0 and Ipos = 4 in the laminate entity editor but when I visualise the laminate, it appears to be symmetric about the geometry. Have I applied a setting incorrectly or does hypermesh always render the laminate this way?

Tagged:

Answers

  • Nadine Kamark
    Nadine Kamark
    Altair Employee
    edited September 25

    Visualisation of composite offset is not supported yet. It will most likely be supported in the 2025 release. 

Categories