The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Hello,
after create a tetramesh, i get an error message 'Input leaks, 2 edges found'.how can I locate these edges or how can I avoid the error? See Figure.
Thank you,kned
Kned,
you can use Edges panel to figure out where the free edges (LEAKS) are.
go to -->Tool page-->Edges.
Thanks and regards
Prakash Pagadala
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…