i have a issue on hyperworks contour plot has not showing and the cad surface looking like the duplicate surface but in actually its single. i had applied new license and installed whole setup but issue had not resolve.

PAWAN BHOYAR

 

Image :1  contour displacement is didn't displayed on the left side of the simulation.

 

 

 

image :2 - surface looking like the duplicate but i was created in once, this issue want to resolve.

Jason_Craanen

Hello, 

This looks like a Graphics Driver issue.

Refer to this article

https://community.altair.com/community/en/altair-hyperworks-hardware-and-system-requirements?id=kb_article&sysparm_article=KB0119809

And make sure you are using a recommended driver

https://2022.help.altair.com/2022/hwdesktop/altair_help/topics/getting_started/hw_recommendation_certifications_intro_r.htm#reference_b5n_53c_d1b

Installed using custom/clean option