Stress results not showing in Hyperview
Hello there,
I am trying to simulate the residual stresses and strains of a composite panel after a temperature change to evaluate the springback. To do so, I am using HM as the pre-processor and HV as the post-processing tool, and MSC Nastran as the solver. I am currently running SOL 400 (non linear implicit) analysis and I get my OP2 file and f06 just fine. When I load my results (bdf and op2) in Patran I can see them fine, but when I try to do so with HV, I can only visualize displacements and SPC forces but not Stress or Strain. It seems as those results where not loaded into HyperView. What can I do to solve this?
If it helps, here is the beginning of my bdf file.
SOL 400
CEND
$$------------------------------------------------------------------------------$
$$ Case Control Cards $
$$------------------------------------------------------------------------------$
SUBCASE 1
STEP 1
ANALYSIS = NLSTATIC
NLSTEP = 1
SPC = 2
TEMPERATURE(INITIAL) = 4
TEMPERATURE(LOAD) = 5
DISPLACEMENT = ALL
ELFORCE = ALL
NLSTRESS = ALL
OLOAD = ALL
SPCFORCES = ALL
STRAIN = ALL
STRESS = ALL
$$------------------------------------------------------------------------------$
$$ Bulk Data Cards $
$$------------------------------------------------------------------------------$
BEGIN BULK
PARAM NOCOMPS 1
PARAM PCOMPRM 1
PARAM SRCOMPS YES
PARAM POST 1
PARAM LGDISP 1
PARAM PRTMAXIM YES
NLSTEP 1
$$
My MSC Nastran version is the 2016 one and my Hyperworks version is the 2019.0.0.70.
If it helps, I have tried to use the CSTRAIN/CSTRESS cards as output requests but they seem to not work in Nastran.
Thanks in advance.