The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Hello,I have problems integrating Altair Flux 2018.1 into Matlab Simulink R2017bI started Matlab 2017b from the supervisor, and followed these steps :https://community.altair.com/community?id=community_question&sys_id=3d66ccf61b2bd0908017dc61ec4bcbf5&view_source=searchResultI made sure the path variables are set in Matlab.But when I simulate, after compiling, i get the following error:Caused by:Error reported by S-function 'Flux_Simulink' in 'motor_control_with_flux/Coupling with Flux1': Error while calling init : Class initApi not found in rsi/fluxmp/FluxMPAPI
Thanks in advance!Kind Regards,Steve Oswald
Hi,
May be the problem come from the Matlab Simulink version that you use.
Best regards.
