Doubts to see graphs related to forces, accelerations, springs and dampers.

Josep Roig

Hello to all,

I am starting to use the Motion view system to learn how to simulate the formula student of my university and I have made with the templates the most similar model that we have.
I have done the kinematics and compliance analysis and I can't see the force and acceleration graphs. How can I see them?
On the other hand, I would also like to see how K and C are affected and to see a senoidal graph to see how the damper acts.

Thank you very much.

 

Adriano_Koga

i'm not a MS expert, but i believe you need to request these as 'outputs' to be written to your .abf files, and then plot them into HyperGraph.

 

Try going though the tutorials too. They show you these output requests and plot.