Pinion and Rack simulation at MotionView
Hi, I need to simulate a pinion/rack system, but my rack is going to be fixed to the ground, and the pinion is the one translating and so on is going to rotate, but I dont understand how to work with the translational component in order to create the coupler.
If anyone knows how to solve my issue I will be grateful!!
Thanks
Answers
-
Hi
Maybe these tutorials can help on your modeling
MV-1026: Model Curve-to-Curve (CVCV) Higher-Pair Constraint
and
MV-1010: 3D Mesh-to-Mesh Contact Simulation
Regards
0 -
Rogerio Nakano_21179 said:
Hi
Maybe these tutorials can help on your modeling
MV-1026: Model Curve-to-Curve (CVCV) Higher-Pair Constraint
and
MV-1010: 3D Mesh-to-Mesh Contact Simulation
Regards
Hi
I also been trying to simulate a 3d mesh to mesh contact, but the solver always fails. I dont know what can be hapening.
0 -
Juan Esteban Mora Zarate said:
Hi
I also been trying to simulate a 3d mesh to mesh contact, but the solver always fails. I dont know what can be hapening.
Hi
the tutorial models fail as well?
Regards
0 -
Rogerio Nakano_21179 said:
Hi
the tutorial models fail as well?
Regards
Hi
they work fine, also I have a geneva machanism that works fine, but this pinion and rack simulation fails, and if I open de .h3d to see where the simulation fails. It fails instantly.
0 -
Juan Esteban Mora Zarate said:
Hi
they work fine, also I have a geneva machanism that works fine, but this pinion and rack simulation fails, and if I open de .h3d to see where the simulation fails. It fails instantly.
Hi
I suggest then you share your model with your Altair's local support .
Regards
0