How to startup hyperview NoGUI and run tcl by cmd

Jerry Qu
Jerry Qu Altair Community Member
edited September 2022 in Community Q&A

1.Hyperview not Hypermesh

2.-tcl

3.noGUI and exit hyperview when tcl complete 

4.win cmd

Tagged:

Answers

  • Nagahashi Kouta
    Nagahashi Kouta Altair Community Member
    edited September 2022

    Hi, Jerry

    The command below will help you .

    "D:/HyperWorks2019/hw/bin/win64/hw.exe" -b -clientconfig hwpost.dat -tcl "E:/test.tcl"

  • Jerry Qu
    Jerry Qu Altair Community Member
    edited September 2022
    Nagahashi Kouta said:

    Hi, Jerry

    The command below will help you .

    "D:/HyperWorks2019/hw/bin/win64/hw.exe" -b -clientconfig hwpost.dat -tcl "E:/test.tcl"

    Thank you so much , that’s very helpful.
  • Nagahashi Kouta
    Nagahashi Kouta Altair Community Member
    edited September 2022
    Jerry Qu said:

    Thank you so much , that’s very helpful.

    Hi, Jerry

    If your problem has been solved, please close this question for other's convience.

Categories