How can i apply Periodic Boundary condition and nodal boundary condition ? [ACUSOLVE-Hypermesh]

Juan Felipe Garzón Romero

Hello everyone. 

Recently I have tried to recreate a validation problem 

https://2021.help.altair.com/2021/hwsolvers/acusolve/topics/acusolve/turbulent_flow_through_a_heated_periodic_channel_2.htm?zoom_highlightsub=turbulent+flow+through+a+heated+periodic+channel

However, I didn't find how can I apply some simulation settings and where to apply these settings in hypermesh acusolve, specifically the individuals periodic Bcs and nodes. How can I simulate those settings using hypermesh acusolve? 

also, I did this mesh with these components: 

 

acupro

I encourage you to try the new HyperWorks CFD product - in the newly released 2021.1 version.  This will make your CFD setup so much easier.  It also supports periodics (but you may need to do some final manual-editing of the .inp file as not everything is 100% supported yet in the GUI).  You'll need the hwDesktop2021.1 and hwCFDSolvers2021.1 packages.