TCl scripting

karth
karth Altair Community Member
edited October 2020 in Community Q&A

I am performing NVH simulation in which, the forces from flux are obtained as a bulk file which are then needed to be imported into optistruct.

Since, there are some issues that are being faced in the flux-optistruct interfacing, I would like to import the forces from bulk file into Optistruct using TCL scripting commands,

Is that possible. If so, what are the main commands that would be used in such a case?

Tagged:

Answers

  • tinh
    tinh Altair Community Member
    edited October 2018

    First please tell why you don't import bulk format forces using GUI?

  • karth
    karth Altair Community Member
    edited October 2018

    I had imported the bulk file and processed the solve. But, it yielded rload2 data missing error.

    When tried to recreate the force file by importing the tooth profile from Optistruct to Flux, it yielded exception error which were unable to be resolved. 

    And hence, I am trying to use the available force file to get imported into Optistruct using scripting method.

  • tinh
    tinh Altair Community Member
    edited October 2018

    So what is cause of the error?

  • karth
    karth Altair Community Member
    edited October 2018

    Hi, due to the fact that the cause of the error is unknown, I am trying the alternate way.

  • tinh
    tinh Altair Community Member
    edited October 2018

    Scripting is just what you did on GUI

    You should find out the cause first.

Categories