Axisymmetric forming simulation

rzmehdipour

Hi all,

 

Is it possible to simulate axisymmetric forming process in Hyperform by defining a section-cut of tool components and part using 1-D or 2-D elements? For example for cylindrical deep drawing, tube endforming and the same. 

 

Thanks in advance.

Junta_20361

Altair Forum User said:

Hi all,

 

Is it possible to simulate axisymmetric forming process in Hyperform by defining a section-cut of tool components and part using 1-D or 2-D elements? For example for cylindrical deep drawing, tube endforming and the same. 

 

Thanks in advance.

hi rzmehdipour,
I don't think there is any option in HF supports for your request.
Basically, HyperForm is a combination of scripts base on Radioss.
Regarding to your request, you should use HyperMesh with Radioss user profile directly.

Thanks!

rzmehdipour

Altair Forum User said:

hi rzmehdipour,
I don't think there is any option in HF supports for your request.
Basically, HyperForm is a combination of scripts base on Radioss.
Regarding to your request, you should use HyperMesh with Radioss user profile directly.

Thanks!

Thanks a lot for your reply