automesh pannel technique

hello every one ,

when i make mapped mesh in washer region its not came in mapping mesh , as further to increase number of nodes only came in mapped mesh,

please check below videos and also attached model file check it and give solution

Unable to find an attachment - read this blog

Find more posts tagged with

English

HyperMesh

Accepted answers

All comments

Rahul Rajan_21763

Sometime it happens because of Geometry.May be fixed point in your case could be the problem.I would recommend Ruled command with linelist to linelist option for such case.

tinh

I think the two fixed points are already in conform position

The cause you cannot make mapped mesh is: using element type 'quad'

change it to type of 'mixed' and try again

yukesh.aero

@Rahul @tinh if possible Fixed point change it , some of Fixed point cannot be remove using F11 command

Rahul Rajan_21763

(F11)Quick edit : Add/remove point would work

yukesh.aero

@rahul I used F!! command BUT some Cannot remove Fixed point

Rahul Rajan_21763

Fixed point comes where lines are intersecting.