The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
I cannot select loads when defining my constraints. The model I am using for this is a imported .ipt model. Am I defining the part wrong?
Bert,
I don't see any Elements/Nodes to apply loads/constraints to in your model. Did you mesh it?
Bert, I don't see any Elements/Nodes to apply loads/constraints to in your model. Did you mesh it?
Jason,
The solid is not meshed yet. However, I have tried to do a 2D batch mesh of the figure, but it looks like the mesh is not compatible for that.
Jason, The solid is not meshed yet. However, I have tried to do a 2D batch mesh of the figure, but it looks like the mesh is not compatible for that.
Depending on how you are going to mesh it (2d or 3d) and size will determine which tools to use. But I don't see there should be any issue. Once it is meshed, then you should be able to apply loads/BCs to the elements or nodes.
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…