segmentation error in hypermesh

Hello Jayesh,

I would start by looking at this article

https://community.altair.com/community?id=kb_article&sysparm_article=KB0119809

Focusing on the graphics

And deleting the temporary settings files to start with

Is this issue model specific?

Workflow specific?

More details are always helpful

Thanks

jason

Hello Jason,

         I am performing thermal stress analysis and created 'temp' load collector, and when I went in temperatures panel to apply temperature, while selecting all nodes I got 'segmentation error' message and in left bottom corner it displayed 2995 nodes selected.

Hello Jason,

         I already deleted all setting files but still I am getting this error.

Hello Jason,

         I already deleted all setting files but still I am getting this error.

 

Have you looked into any of the other recommendations in the article?

I don't have dedicated graphics card on my laptop but it was perfectly working till now but it's throwing segmentation error now while I select ALL nodes. Below are my system specs:

Processor    Intel(R) Core(TM) i5-1035G1 CPU @ 1.00GHz   1.19 GHz
Installed RAM    8.00 GB (7.79 GB usable)
System type    64-bit operating system, x64-based processor

I don't have dedicated graphics card on my laptop but it was perfectly working till now but it's throwing segmentation error now while I select ALL nodes. Below are my system specs:

Processor    Intel(R) Core(TM) i5-1035G1 CPU @ 1.00GHz   1.19 GHz
Installed RAM    8.00 GB (7.79 GB usable)
System type    64-bit operating system, x64-based processor

Jayesh,

A dedicated graphics card is required.

Please refer to the below list of them.

https://community.altair.com/community?id=kb_article&sysparm_article=KB0119809

https://2022.help.altair.com/2022/hwdesktop/altair_help/topics/getting_started/hw_recommendation_certifications_intro_r.htm#reference_b5n_53c_d1b

Thanks