The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Currently I am preparing water tight model for CFD drag analysis. There are too many surfaces, I want to know how to handle hypermesh tools to get fill gaps fast. Some one can help me to fill all the gaps in cad.
Hi,
In the link below you can find a small article listing all the steps that could be followed in HyperWorks CFD to extract a water-tight model for an internal cavity.
https://community.altair.com/community?id=kb_article&sys_id=dc90040fdb3e6590cfd5f6a4e296196a
Even though in your case you are probably not interested in the internal cavity you can use the same tools to create a closed watertight body. In fact, conversion to FE and the Cap tool (inside the FE tools) will be particularly helpful to close holes automatically.
Regards,
Geo
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
Join us for a community conversation to explore how different modeling approaches in Simcenter PSIM can help engineers simulate power electronics systems while balancing accuracy, simulation speed, and design insight. What you'll learn: Power transistor modeling : Thermal and high fidelity models Protection component…