How can I connect two different meshes, which cross each other, so that they have one shared line?

Manuel_21421

I did a Modalanalysis of my model, where I realized that two meshes, which are crossing each other, are not connected. This applies in some different parts aswell, where propably a gap between the parts appears. I created the midsurfaces of my model and meshed them.

So my question is: can I connect the two crossing meshes or do I have to connect the parts of the middle surfaces? And how do I do that?

The other problem are the areas where I have a T-junction, but some lines are yellow and later in the Modalanalysis it shows there is no connection between the two parts.

 

Thanks in advance!

 

1_Eigenmode.png

Marine_Racollet

Hello,
Before the submition of your run you can check if all your nodes are connected.
In HyperWorks Next Generation : Validate > Free Edges.
In HyperMesh Classic : Mesh > Check > Nodes > Equivalence.