The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
hi all
I have just started to use hyperview. I open gpforce and gpstress cards and load the results.
I understand that hyperview shows element stress. However i could not find nodal stress values?
How can i see the nodal stress?
Best Regards
Hello,
You have to request the corner stresses (see pic. 1) and then you must switch on the 'Use corner data' in Hyperview (see yellow marker).
Best Regards,
Mario
<?xml version="1.0" encoding="UTF-8"?>
Hi Mario
Thanks for your effocts.
Regards
Join us for a community conversation on how High-Performance Computing (HPC) and Simcenter PSIM work together to meet the increasing demands of modern power electronics simulation. During this one-hour technical session, you'll discover how leveraging HPC can speed up simulations, improve scalability, and empower engineers…
Join us for a community conversation on accelerating your motor simulation workflow with Simcenter Simlab. In this beginner-friendly session, we'll introduce the platform's automated model-building capabilities and show how easy it is to set up your first electric motor analysis. You'll see the basic steps of geometry…
Join us for a Community Conversation where we'll discuss practical approaches to analyzing complex electromagnetic models using hybrid solver techniques. This session will provide a general overview of how different computational methods can be combined within a single simulation to address models containing varied…
