The Siemens Community Catalyst program was co-created with our community to acknowledge technology leaders who consistently contribute to the Siemens Community. Nominations are accepted on a rolling basis.
Hi all,
I'm using HyperMesh to set up a linear static for Abaqus interface. I use element DCOUP3D to create a distributed load. But when I run in Abaqus, it said that this keyword is not yet supported.
How can I do to fix this error?
Thanks all.
Hello,
Can you please verify where you are seeing this error?
Is this when running abaqus or in CAE?
Either way, it would be an issue to ask Abaqus support.
thanks
