Problem with importing ABAQUS .inp file

Altair Forum User
Altair Forum User
Altair Employee
edited October 2020 in Community Q&A

Hi everyone,

 

I created a textile model using TexGen which allows me to directly create ABAQUS .inp file (I am using voxel mesh). This file can be opened perfectly in ABAQUS. However, when I tried to import the same file to Hypermesh (through import-->solver deck-->the ABAQUS .inp file), the file cannot be opened. Could somebody please kindly give me a suggestion on how to solve this problem? Thank you.

Tagged:

Answers

  • Rahul Rajan_21763
    Rahul Rajan_21763 New Altair Community Member
    edited August 2016

    If it gives any error please share.Meanwhile i will check same in Hm interface userguide.

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited November 2020

    Hello Rahul,

     

    Thank you for your reply. Yes it does give me an error message. However, I believe there is something wrong with the Hypermesh installation in my university as the error log never describes what the errors are about, Hypermesh only states 'Permission Denied'. Attached in this reply is the ABAQUS .inp file that I have been trying to import to Hypermesh. Could you be so kindly to check if you can open the file? Appreciate it!

    Unable to find an attachment - read this blog

  • Rahul Rajan_21763
    Rahul Rajan_21763 New Altair Community Member
    edited August 2016

    I able to import shared file in 14.0 version with some warning.

    Refer below post for Permission denied error.

     

  • Altair Forum User
    Altair Forum User
    Altair Employee
    edited September 2016

    Hi Rahul,

     

    Thank you for your kind reply. Yes I did try importing the same file to Hypermesh installed in friend's desk computer and it worked. I am currently trying to re-install my Hypermesh. Thank you very much

     

     

Categories