RADIOSS error msg-translation reqd


Hallo Everyone,
Does any one know what does it mean when one gets a error msg like this,
'Invalid component number on SPC for GRID #36160'
i have applied SPC constraints on nodes. these nodes are center nodes which are connected to the surrounding nodes by a RBE 2 element.
Thanks in advance...
Does anyone actually know how to use HyperWorks? I'm getting the same error, but I can see this has not been resolved since 2011...
Hi
This is for optistruct {--------------------
Could you share your model file?
i made such SPC but there is no error
edit card of the SPC (loads) you should see af field #3 one combination of 6 dofs (123456)
}---------------------------------------------------------------------------------
for radioss, constraints must be in card defined load collector (BCS)
edit card for that collector then activate dof (component number) will be constrained
default component number is 0 so solver raises such error, perhaps

Hi
This is for optistruct {--------------------
Could you share your model file?
i made such SPC but there is no error
edit card of the SPC (loads) you should see af field #3 one combination of 6 dofs (123456)
}---------------------------------------------------------------------------------
for radioss, constraints must be in card defined load collector (BCS)
edit card for that collector then activate dof (component number) will be constrained
default component number is 0 so solver raises such error, perhaps
I m trying to compute FRF for Fully free (FFFF) plate but get same SPC errror how to solve this problem
Does anyone actually know how to use HyperWorks? I'm getting the same error, but I can see this has not been resolved since 2011...